Ricoh G112 Instruções de Operação descarregar pdf (Página 181)

Monitoring and Configuring the Printer

181

Remote Maintenance by telnet

❒ Remote Maintenance should be password-protected so that access is al-

lowed to administrators only.

❒ The password is the same as the one of Web Image Monitor administrator.

When the password is changed using “mshell”, other passwords change also.

❒ Some commands cannot be used depending on your printer.

Using telnet

Follow the procedure below to use telnet.

❒ Only one user at a time can log on to perform remote maintenance.

A Use the IP address or the host name of the printer to start telnet.

% telnet IP_address

B Enter your user name and password.

To use default account, enter “admin” as user name, and leave the password

blank.

C Enter a command.

D Quit telnet.

msh> logout

The configuration message about saving the changes appears.

E Enter “yes” to save the changes, and then press the {# Enter} key.

If you do not want to save the changes, enter “no”, and then press the {# En-

ter} key. To make further changes, enter “return” at the command line, and

then press the {# Enter} key.

❒ If the message “Can not write NVRAM information” appears, the changes

are not saved. Repeat the procedure above.

❒ When the changes are saved, the network interface board is reset auto-

matically with that changes.

❒ When the network interface board resets, the print job in print process will

be printed. However, print jobs in queue will be canceled.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 298 299

Sem comentários

Ricoh G112 Instruções de Operação Página 181