
Page 26
Version 1.0.2, Revision 1 | Ricoh eQuill Tablet
C
HAPTER
2 : Getting Started
2.4 - Commonly Used Functions and Features
”Turning Off the Tablet” on page 26
”Sleep Mode” on page 26
”Battery Power Indicator” on page 26
”LED Lights” on page 27
”Opening Blank Forms” on page 27
”Deleting a Document” on page 27
”Syncing the Tablet” on page 28
2.4.1 - Turning Off the Tablet
Slide the On/Off button (top of tablet), and hold for seven seconds. The LED will begin
blinking. Release the power button. The LED will continue blinking until the tablet shuts off.
2.4.2 - Sleep Mode
If the tablet is not used for several minutes (configured for the tablet by the administrator—
default is 10 minutes), it will automatically go into Sleep Mode to help conserve power and
extend battery life. You can also place the tablet in Sleep Mode by sliding the On/Off switch to
the left and holding it in this position momentarily.
NOTE:
Using the On/Off switch will not put the tablet to sleep if it is syncing. Wait for the
Sync icon to disappear then try again.
If your tablet is configured to initialize with a login screen, your tablet will go to the login
screen when it is activated out of sleep. The tablet is configured by the eWriter Console to
initialize with a login screen.
If your tablet is not configured to initialize with a login screen, your tablet will go to the Inbox
when it is reactivated.
2.4.3 - Battery Power Indicator
You can determine that your Ricoh eQuill tablet needs to be charged by checking the battery
power indicator at the top right of the screen. If it is down to one thin bar or no bar (less than
20% power), you should charge your tablet. If your tablet is out of power, you will not be able
to turn it on, mark on it, and in some cases, even see the power indicator. If you try to power
on the tablet when it is out of power, the LED indicator will flash red three times. Battery
power states are shown in the following table.
Comentários a estes Manuais